The CB750 Is Back On The Road
Unlike with the Concours when its valve stem went bad, there was no way I could ride my Honda CB750 to the dealer to have the valve stem replaced. I have no idea why that Concours tire still held air but the Honda tire did not. I had already had it towed to my house and was reluctant to have it towed again to the dealer, so the other option would be to remove the wheel and take the wheel to the dealer.
With the wheel off I strapped the bike to a vise for added stability.
The first thing we had to do was put the bike up on its center stand. I knew from when I had a flat on the Concours a few years ago how hard that can be. But that had been a back tire and this was a front tire. It went up easily but then when we tried to jack the bike up high enough to get the tire off it started raising the rear off the ground. The answer was to put a piece of plywood under the center stand, but now it was really hard to get it up. We managed.
Then we needed a block of wood to put between the jack and the crank case. Scraps of wood are something most any guy has laying around but during the Covid lockdown I had done an extensive garage cleaning and had thrown out stuff like stray pieces of wood. I finally came up with a two by four and it was not optimal but it worked. Up on the jack the bike was very unstable so Roy’s job was to hold it steady and give me guidance while I did the work.
It really couldn’t have been much simpler. Remove two bolts and slide the disc brake caliper off, drop the C-clamps at the base of the forks, and disconnect the speedometer. Voila.
I took it to Vickery the next day and a while later they called to say it was ready. I got there and immediately saw they had not put on a 90-degree valve stem, which I had stressed I absolutely had to have. So they got right on it and quickly had it done and I headed home. I should have been clearer on that 90-degree stem but they made it right immediately so I have no complaints.
The next day Roy came over again and we put it all back together. Spread the caliper wide with a couple screw drivers, reassemble the fork ends, reattach the speedo. What I would not have known to do was to compress the shocks a few times to make sure everything set in properly. Roy also warned me not to touch the brakes while it was apart because otherwise they would have needed to have been bled, which would have been an unnecessary pain.
And that was all there was to to it. Great. I love learning how to do new stuff, and this is the kind of thing that may well come in handy in the future.
Biker Quote for Today
My brother recently got into a bikers gang that worships Norse monarchs. They call themselves ‘The Bikings.’
